Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe B
    4. : Replacement of the brake light bulb for the Mercedes B-Class.

Mercedes Classe B - Video tutorial

Model: Mercedes Classe B MK 1, W245 - Years 2005-2011
Part: Rear light bulb
Operation: Replacement of the brake light bulb for the Mercedes B-Class.

Below we will see the instructions that will allow us to disassemble and replace the rear stop light bulb of the Mercedes Classe B. First, we open the rear door of the trunk and start removing the side cover, thus accessing the internal part of the rear light; then we disconnect the electrical connector of the bulbs and remove the bulb holder from the headlight, as shown in the video. At this point, we replace the faulty bulb (in this case, the stop light bulb) with one that has the same fitting; we insert it into the bulb holder and finally make the electrical connection!


Posted on 31 December 2023 by ScegliAuto



How to replace the reverse light bulb on a Mercedes B-Class
Mercedes Classe B (2005-2011 / MK 1, W245) .. to go to open the tailgate of our Mercedes B-Class. Let's start then by going to disengage and remove the internal side cover of the luggage compartment...
How to replace the reverse light bulb on a Mercedes B-Class?
Mercedes Classe B (2005-2011 / MK 1, W245) .. of the luggage compartment of our Mercedes B-Class. Let's start then by going to disengage and remove the internal side cover of the luggage compartment...
Mercedes B-Class W245 headlight bulb replacement
Mercedes Classe B (2005-2011 / MK 1, W245) Let's see the procedure necessary for the disassembly and replacement of the headlight bulb of the Mercedes B-Class W245, first series. First we open

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos