Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Shock Absorber

Model: Mercedes Classe A W168 - Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004
Part: Shocks

See other generations:
Video tutorial

Place the car on a lift to access underneath the body. Remove the two screws of the protective cover with an 8mm socket wrench and take it off. Also remove the second cover.

Using a 18mm ratchet wrench, unscrew the securing bolt of the shock absorber. Position a hydraulic jack under the wheel arm to support it. Using a hammer and a screwdriver, slide out the retaining pin of the shock absorber and remove it after taking off the spring and all the support.

Install the new shock absorber by securing it to the support with the bolt and tightening the nut with a 16mm wrench. Raise the arm with the jack to allow for the support to be secured.

Tighten the bolts and install a new spring, securing it with the bolt that should be greased before fastening. Reassemble the remaining components.


Updated on 2 February 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Shocks of the Mercedes A-Class
How to Replace the Rear Shocks of the Mercedes A-Class
Mercedes Classe A (1997-2004 / W168) Replacing the rear shocks on this model is a job that can be easily done yourself and becomes even simpler if you have a lift; start by raising the v…
Rear Shock Absorber Replacement for Mercedes A-Class
Rear Shock Absorber Replacement for Mercedes A-Class
Mercedes Classe A (2004-2012 / W169) .. Replacing the rear shock absorbers is significantly easier than the front ones since the spring and shock.. …
Rear Shock Absorber Replacement Instructions
Rear Shock Absorber Replacement Instructions
Mercedes Classe A (1997-2004 / W168) To replace the rear shock absorbers, you need a lift and a hydraulic jack; lift the vehicle on the lift and remove the rear wheel; locate the two mou…

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos