Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : How to replace the rear turn signal bulb on the Mercedes C-Class W203

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W203 - Years 2000-2007
Part: Light bulb
Operation: How to replace the rear turn signal bulb on the Mercedes C-Class W203

In this video we see how to replace the rear turn signal bulb of the Mercedes C-Class W203: so first of all we need to open the rear trunk and remove the carpet lining that we find corresponding to the rear light. We find a black lever that we need to turn 90 degrees, and so we can pull towards us the plate with the bulbs. The rear indicator bulb is orange 12V 21W, so make sure you have a spare before doing the operation. To remove it, just turn it counterclockwise. This bulb has offset pins, so make sure the one you buy also has them. To put it back in place, we will turn it clockwise, then put the plate back in place and close the black lever. We can also close the carpet lining and the job is done.


Posted on 18 February 2024 by ScegliAuto

    Frequently Asked Questions

    • Classe C 2007-2013 - What does the wording "Light Error" on the Mercedes W204 indicate? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos