Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Interior Bulbs of the MG 3?

Model: MG 3 MK 3 - Years: 2024, 2025, 2026
Part: Light bulb

See other generations:
Video tutorial

The courtesy lights pre-installed by the manufacturer on the MG 3 provide a warm light that is not particularly functional. If desired, you can replace them with bulbs that have greater brightness, whether they are standard or LED, following the video tutorial provided.

Start by removing the dome light that is snap-fitted: you will simply need a coin or any flat object to detach it from its housing. Next, disconnect the electrical connector and then proceed to remove the bulbs you intend to replace.

After installing the new ones, you can reattach the dome light in its place.


Posted on 7 September 2026 by ScegliAuto


Related tutorials

How to Replace the Cabin Filter on the MG 3?
How to Replace the Cabin Filter on the MG 3?
MG 3 (2011-2024 / MK 2) To replace the cabin filter on the MG 3, open the glove compartment located on the passenger side. This allows you to detach the internal fastening p…
How to Replace the Headlight Bulbs in the MG 3?
How to Replace the Headlight Bulbs in the MG 3?
MG 3 (2011-2024 / MK 2) As shown in this tutorial, replacing the headlight bulbs in the MG 3 is a very simple and quick task. First, ensure the key is not in the ignition fo…
How to Replace the Rear Headlight Bulb on the MG 3?
How to Replace the Rear Headlight Bulb on the MG 3?
MG 3 (2011-2024 / MK 2) To replace the rear headlight bulb on the MG 3, open the trunk of the car to access the two screws next to it. Once the screws next to the gasket are…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos