Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the air filter in the MG HS?

Model: MG MG Various
Part: Air filter

In this tutorial we can see how to replace the air filter in the MG HS, an extremely simple and fast operation. Before proceeding, make sure the engine is completely cold in order to operate safely. We start by opening the hood, then we identify the airbox located behind the right headlight, unscrew each screw located along its perimeter and disconnect the sensor connector. Once this is done, we lift the top half of the box, take out the old filter and clean the inside of the housing of any residual dirt. Finally, we follow the reverse procedure to put everything back together.

Posted on 28 September 2022 by ScegliAuto

Video tutorial

Related tutorials

How to replace the air filter in an MG.
How to replace the air filter in an MG.
MG MG Various In this video tutorial, we can see how it is possible to replace the air filter in an MG by following some simple steps: the first thing to do is to …
How to replace the air filter in the MGF.
How to replace the air filter in the MGF.
MG MG Various In today's video, you will see how to replace the air filter in the MGF; this also applies to the subsequent MG TF, as the car is based on the same p…
How to replace the cabin air filter on the Mg Rx5
How to replace the cabin air filter on the Mg Rx5
MG MG Various Let's see in this guide how to remove and replace the cabin air filter of the Mg Rx5, in simple and quick steps. First we get on board the car, on th…

Other guides you may be interested in

How to Install Roof Bars on a Fiat 500L

Learn how to fit universal roof bars on a Fiat 500L. These bars are used on vehicles with or without roof rails. Assemble the roof bar kit (as shown in the video) with bars adjusted to the width of the vehicle (measure with a tape measure). Position the brackets at both ends of the doors on the vehicle's original roof rails. Once the anchoring bracket width is set, tighten the bolts with a butterfly nut (if a lock is present) until fully secured to the roof rails. Fit safety caps on both sides.

Watch the video!


by ScegliAuto

More videos