Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you reset the Mini's Service light?

Model: Mini Mini R53, R52, R50 - Years 2001-2007
Part: Service warning light

To reset the Service light on the Mini One, you will need to turn on the instrument panel by turning the key inside the ignition block: once it is turned on, you can press and hold the button located on the right side of the instrument panel until the "rST" message flashes. When the light is flashing, you can release the button and then press it again; this will reset the Service light completely and restore the maintenance interval. Finally, you can turn off the instrument panel.

Posted on 8 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How do you reset the Service light in the Mini F57?
How do you reset the Service light in the Mini F57?
Mini (2014-2023 / F56, F57, F54, F55) It is noted that the procedure for resetting the Service light, shown in this video guide, is generic in nature; in fact, it is standard among variou…
Service Reset on a Mini Clubman
Service Reset on a Mini Clubman
Mini (2007-2014 / R56, R55, R57) How to reset the service on a Mini Clubman? Let's see how to reset the service light. Turn on the instrument cluster and check the warning light. Pre…
How to reset the Service light on the Mini One?
How to reset the Service light on the Mini One?
Mini (2001-2007 / R53, R52, R50) To reset the Service light on the Mini One, turn on the ignition by rotating the key in the ignition switch: once it is on, press and hold the button…

    Frequently Asked Questions

    • Mini 2010-2016 - Why does the oil warning light come on on the Mini Cooper? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos