Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Adjust the Valve Clearance on a Moto Guzzi V7

Model: Moto Guzzi V 7
Part: Valve

Video tutorial

Let's see how to adjust the valves on the Moto Guzzi V7: first, position the piston at top dead centre (TDC) during the compression stroke by rotating the engine until both valves are closed. The recommended clearances (standard for the V7) are 0.15 mm for intake and 0.25 mm for exhaust.

To perform the adjustment, loosen the locknut on each valve, adjust with a flat screwdriver until you feel slight resistance with the correct feeler gauge inserted, hold the adjustment steady, and tighten the locknut. Then, recheck that the feeler gauge passes with slight friction.

Ensure the upper feeler gauge does not pass. Rotate the engine again (2/3 turns) and return to TDC during compression, then recheck the clearances which should be as set. Use only precise tools and adjust only when the valves are closed.


Posted on 7 July 2026 by ScegliAuto


Related tutorials

How to Replace the Exhaust of the Moto Guzzi V7
How to Replace the Exhaust of the Moto Guzzi V7
V 7 To replace the exhaust of the Moto Guzzi V7, first loosen the screw located at the rear of the exhaust itself, corresponding to the support. Once thi…
How to Remove the Rear Mudguard of the Moto Guzzi V7?
How to Remove the Rear Mudguard of the Moto Guzzi V7?
V 7 To remove the rear mudguard of the Moto Guzzi V7, first remove the seat to access the screws underneath. The screws to loosen are located on the side…
Installing Biondi Fairings on a Moto Guzzi V7
Installing Biondi Fairings on a Moto Guzzi V7
V 7 Learn how to install an aftermarket fairing from Biondi on a Moto Guzzi V7. Unscrew one of the two screws that secure the headlight to its brackets, …

How to Replace the Transmission on the Beta RR 50?

To replace the transmission on the Beta RR 50, loosen the central nuts that secure the sprockets around which the chain is placed: these will be on the left side of the bike. The sprocket will be located in line with the left footpeg, while the other sprocket will be in line with the rear wheel. Once the sprocket is removed, you can completely detach the chain and the respective sprockets by unscrewing the nuts that secure them. At this point, install the new sprockets and position the chain around them to verify that everything is functioning.

Watch the video!


by ScegliAuto

More videos