Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Nissan
    3. :
  3. Rogue
    4. : How to replace the rear light of the Nissan Rogue

Nissan Rogue - Video tutorial

Model: Nissan Rogue S35 - Years 2008-2015
Part: Tail light
Operation: How to replace the rear light of the Nissan Rogue

In today's video tutorial we will see how to disassemble and replace the rear light of the Nissan Rogue, following these simple steps. First of all we open the tailgate and start by removing the small plastic cap that we find behind the light; then we unscrew the screw that we find below, also removing those located under the luggage compartment shelf, as shown in the video. Once all the screws of the headlight have been removed, we can lever the sides to disassemble it; finally disconnect the electrical connector to replace the optical group, following the video to the end!


Posted on 12 April 2024 by ScegliAuto



How to replace the rear light bulb on the Nissan Rogue?
Nissan Rogue (2008-2015 / S35) In order to replace the rear light bulb of the Nissan Rogue you have to go to open the trunk lid, so that the bolts next to the headlight can be unsc
Replacing the rear light bulbs of the Nissan Rogue 1
Nissan Rogue (2008-2015 / S35) Let's see in this short guide how to remove and replace the rear light bulbs of the Nissan Rogue first series, in simple steps. First of all we open
How do you replace the rear light bulb on a Nissan Rogue?
Nissan Rogue (2014-2020 / T32) Replacing the rear light bulb on the Nissan Rogue is done by opening the tailgate, so that you can locate the screws that secure the light unit to it

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos