|
Do it yourself
| |||
| ||||
How to replace the rear brake pads and discs on the Nissan Qashqai
Model: Nissan Qashqai
J10
- Years 2006-2014
To replace the rear brake pads and discs, start by lifting the rear of the car. Remove the bolts from the right rear wheel to take it off. Once the wheel is removed, unscrew the bolts holding the upper bracket of the caliper using a socket or spanner of 14mm. After unscrewing the top of the caliper, hold it up and remove the old pads. With the pads removed, use a 19mm socket to take off the bracket on the disc that holds the pads. After removing the bracket, use a flat screwdriver to remove the rubber cap on the disc, rotating it until you find a hole to release the disc. Insert a screwdriver to disengage the disc and tap it gently with a hammer to remove it. Once the disc is off, clean the rear hub with a wire brush, fit the new disc, insert the screwdriver to secure the disc, reattach the pad bracket to the disc by tightening the rear bolts, place the new pads on the bracket with the friction side against the disc, reposition the caliper on the pads, use a special tool to retract the caliper piston, and secure it by tightening the rear bolts. Finally, reattach the caliper, put the wheel back on, and you can test the new pads.
Updated on 12 August 2026 by ScegliAuto
Video tutorial
Related tutorials
Nissan Qashqai
(2006-2014 /
J10)
Today, this tutorial video will show you how to remove and replace the rear brake pads and discs on the first generation Nissan Qashqai J10. First, l…
Nissan Qashqai
(2006-2014 /
J10)
In this video tutorial, you will learn how to remove the brake discs and pads from a Nissan Qashqai. First, lift the vehicle with a jack and use a sp…
Nissan Qashqai
(2006-2014 /
J10)
Let's look at replacing the rear brake discs on a Nissan Qashqai along with the pads. After removing the rear wheel, undo the pins of the brake calip…
Other guides you may be interested in
|
How to Open a Stuck Boot on the Peugeot 407?
On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.187
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |