Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing and Replacing Stabiliser Bar Links

Model: Vauxhall Corsa Corsa D - Years 2006-2014
Part: Axle shaft

First, remove the protective caps from the wheel fastening bolts on which you will carry out the repair, loosen the bolts before lifting the vehicle, then raise it with a jack and complete the removal of the wheel (it is advisable to use an axle stand).
Remove the nut securing the link to the shock absorber by holding the link's ball joint with a 17 mm spanner and loosening the nut with a 16 mm spanner; proceed in the same way for the nut securing it to the stabiliser bar.
Then fit the new link and tighten the fastening bolts carefully (hold the ball joint with a 7 mm spanner and tighten the 16 mm nut).
Reattach the wheel and lower the vehicle, completing the tightening of the bolts and reapply the caps on the bolts.

Updated on 3 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Stabiliser Bar on the Opel Corsa
Replacing the Stabiliser Bar on the Opel Corsa
Vauxhall Corsa (2006-2014 / Corsa D) This guide shows you how to remove and replace the stabiliser bar on the Opel Corsa, following the instructions below. First, lift the vehicle and re…
How to Remove the Stabiliser Bar on an Opel Corsa
How to Remove the Stabiliser Bar on an Opel Corsa
Vauxhall Corsa (2000-2006 / Corsa C) In this video, see how to remove the stabiliser bar on an Opel Corsa. Here’s the procedure: position your car on a column lift, raise it to a comfort…
Replacement of Anti-Roll Bar Support
Replacement of Anti-Roll Bar Support
Vauxhall Corsa (1993-2000 / Corsa B) The car's suspension features a unique mounting scheme to the vehicle's chassis: the anti-roll bar consists of two parts, the classic bar connecting …

How to reset the tyre pressure warning light on the Suzuki Jimny?

To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off.

Watch the video!


by ScegliAuto

More videos