Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Radiator Fan Resistor

Model: Vauxhall Corsa Corsa C - Years 2000-2006
Part: Radiator

Irregular operation of the cooling fan may be caused by damage to the resistor that controls the fan speed. Removing the resistor is very simple; it is located at the top of the electric fan support, near the radiator hose: disconnect the connector, unscrew the fastening screw, and pull it out of its housing; you will notice damage to the insulation of the coil. Then install the new resistor by tightening the corresponding fastening screw and reconnecting the connector. Check the activation of the fan once the temperature is reached.

Updated on 11 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the cooling radiator on the Opel Corsa
How to replace the cooling radiator on the Opel Corsa
Vauxhall Corsa (1993-2000 / Corsa B) Today's main steps will show us how to disassemble and replace the engine cooling radiator of the Opel Corsa. First, we open the hood of the car and …
How to remove the radiator of the Opel Corsa
How to remove the radiator of the Opel Corsa
Vauxhall Corsa (1993-2000 / Corsa B) Let's see in this guide the instructions on how to disassemble and replace the cooling radiator of the Opel Corsa. First we open the engine hood of o…
How to Replace the Cooling Fan
How to Replace the Cooling Fan
Vauxhall Corsa (2000-2006 / Corsa C) The car's cooling fan is designed to lower the temperature or maintain it at relatively low levels. The following guide shows how to change this fan.…

Removing and Replacing a Front Headlamp of a Lancia Lybra

This video explains how to remove and replace the front headlamp and its bulbs on a Lancia Lybra. The car has a very simple and quick headlamp removal system. To start, lift the bonnet, reach into the engine bay, and (specifically at the rear of the headlamp) unclip the metal tab that secures the headlamp, then use a screwdriver to undo the few Torx screws. After removing the screws, unclip the headlamp and pull it out from the bumper, disconnect the power connectors, and replace any damaged bulbs or the entire unit. The reassembly phase is very straightforward: insert the headlamp into the bumper housing as shown in the video, secure the metal tab until the headlamp clicks into place (screw in the securing screws). Finally, test the correct operation of the lights.

Watch the video!


by ScegliAuto

More videos