Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install a Car Logo Projection Light Kit

Model: Vauxhall Astra Astra H - Years 2004-2010
Part: Accessory kit

This video shows the installation of lights that project the Vauxhall Motors logo onto the ground from the bottom of the open door. First, remove the light panel located on the roof of the vehicle's cabin. Disconnect the cabin light wiring; it consists of four wires; cut and strip the white and red wires and connect them with insulating tape to the negative and positive terminals of the wires that will power the small projector lights. Reinstall the light panel. The next step is to remove the inner door panel: it will be drilled to allow the installation of the light that projects onto the asphalt. The connection will run through the door hinge.

Updated on 12 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Install a Higher Performance Air Filter
How to Install a Higher Performance Air Filter
Vauxhall Astra (1998-2006 / Astra G) Here is a video to understand how to change the air filter configuration. In this specific case, the filter is broken and completely empty as seen in…
How to replace the bulbs in the rear light of an Opel Astra
How to replace the bulbs in the rear light of an Opel Astra
Vauxhall Astra (1998-2006 / Astra G) How to remove/install the bulbs in the rear light of your Opel Astra? Let's see in this video how to do it correctly. Open the boot. Using a plastic …
How to Replace Interior Lights with LED on Opel Astra K
How to Replace Interior Lights with LED on Opel Astra K
Vauxhall Astra (2015-2022 / Astra K) In this video tutorial, you can see how to replace the interior lights of the cabin with LED on an Opel Astra K. The first step is to prepare a kit o…

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos