Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Replacing the Ball Joint

Model: Vauxhall Astra Astra H - Years: 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Control arm

See other generations:
Video tutorial

To replace the ball joint of the steering rack tie rod, position the vehicle on a lift or on suitable axle stands and remove the front wheel. Then, unscrew the nut securing the ball joint to the wheel hub and use a forked chisel to extract it from its seat; however, before removing the ball joint, unscrew the locking nut to then extract and unscrew the ball joint, counting the number of turns; at this point, screw in the new ball joint with the same number of turns, position it in its seat, tighten the securing nut on the hub, and the locking nut. After installation, it is advisable to have the alignment checked.


Updated on 13 February 2026 by ScegliAuto


Related tutorials

Replacement of Front Suspension Wishbone
Replacement of Front Suspension Wishbone
Vauxhall Astra (2004-2010 / Astra H) Damage to the ball joint or the silent blocks of the front suspension wishbone causes noise, especially when driving on uneven surfaces. To replace i…
Replacement of Rear Bonnet Support Struts
Replacement of Rear Bonnet Support Struts
Vauxhall Astra (2004-2010 / Astra H) The rear bonnet support struts are actually gas springs that tend to deteriorate over time, no longer providing adequate support. These products are …
How to Remove the Front Ball Joint on an Opel Astra
How to Remove the Front Ball Joint on an Opel Astra
Vauxhall Astra (2004-2010 / Astra H) Here’s how to remove the front ball joint on an Opel Astra. First, place the car on a column lift and loosen the wheel nuts with a telescopic spanner…

How to lower the rear seats in the Peugeot 206?

In this tutorial, you will see how to lower the rear seats in the Peugeot 206, a very simple and quick operation, for example, if you need more space in the boot. First, open both the doors and the tailgate, then unclip the seat base and position it vertically. Next, remove the horizontal partition, locate the release levers at the ends of both seatbacks, and, by operating them, lower the seatbacks. To reassemble everything, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos