Do it yourself
| ||||
|
Vauxhall Insigna - Video tutorial
Model: Vauxhall Insigna
MK 1, Insigna A
- Years 2008-2017 In this video we see how to remove the airbag from the steering wheel of the Opel Insignia: we need to turn the steering wheel completely to the right, until we see a small hole at the back. We enter with a small screwdriver and press firmly, while lifting at the same time. Now we turn the steering wheel all the way to the opposite side. We will find a twin hole to the previous one, where we will perform the same operation. The central block of the airbag in the center of the steering wheel will detach itself from its support at this point. All that remains is to disconnect the two electrical connectors, gently using the same screwdriver. If we also need to remove the steering wheel, we will need an appropriately sized Allen wrench to enter the central hole and remove the steering wheel from the steering column.
Posted on 22 September 2023 by ScegliAuto
How do you remove the steering wheel airbag from the Opel Insignia?
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) To be able to remove the steering wheel airbag from the Opel Insignia, you need to start the engine, so that the steering wheel can be turned so that
Where is the airbag control module located in the Opel Insignia?
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) In this video we can see where the airbag control module is located in the Opel Insignia, useful in case we need to remove it due to a fault. As show
How to reset the service light on the Opel Insignia
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) To reset the service of the Opel Insignia, turn on the instrument panel without starting the engine. Press the down arrow on the right side of the st Other guides that may interest you
|
Frequently Asked QuestionsFiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.046
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |