Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Corsa
    4. : How to replace the air filter of an Opel Corsa?

Vauxhall Corsa - Video tutorial

Model: Vauxhall Corsa Corsa D - Years 2006-2014
Part: Air filter
Operation: How to replace the air filter of an Opel Corsa?

To replace the air filter of an Opel Corsa, start by opening the car hood and locating the air filter compartment. This can usually be found near the engine, typically in a rectangular container. Open the clamp or clip that holds the air filter cover in place and remove it. Take note of the orientation of the old filter before removing it to ensure you install the new one correctly. Remove the old filter and clean the area around the filter compartment from any dirt or debris. Install the new air filter making sure it is positioned correctly and securely. Close the air filter cover and make sure the clamp or clip is securely fastened. Finally, close the car hood and ensure it is properly closed. Check the owner's manual for further specific instructions and to know the recommended frequency for replacing the air filter on your Opel Corsa.


Posted on 3 May 2024 by ScegliAuto

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos