Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. : Ranch

Peugeot Ranch - Videoguide

Peugeot Ranch (1996-2008 / MK 1)
How to mount roof racks on a Peugeot Ranch
Let's start by opening the special slots on the roof that will house the seats of the bars. Once these slits are open, we cut 4 centimeters of a plastic tape …read all…
Posted on 26 March 2024 by ScegliAuto
Peugeot Ranch (1996-2008 / MK 1)
How to remove the starter on a Peugeot Ranch
Let's see how to remove the starter on a Peugeot Ranch. We open the engine compartment, disconnect the battery power supply terminals and remove it; disconnect …read all…
Posted on 5 November 2023 by ScegliAuto
Peugeot Ranch (1996-2008 / MK 1)
How to remove the Peugeot Ranch EGR valve
If you notice engine performance problems and also an increase in exhaust fumes, it is likely that the EGR valve may have clogged and that it therefore tends …read all…
Posted on 2 November 2023 by ScegliAuto
Peugeot Ranch (1996-2008 / MK 1)
How to remove the front swing arm of a Peugeot Ranch
Let's see how to remove the front swing arm of a Peugeot Partner. First we put the car on a column bridge and loosen the wheel pins with a telescopic wrench, …read all…
Posted on 31 October 2023 by ScegliAuto
Peugeot Ranch (1996-2008 / MK 1)
How to replace the front swing arm on a Peugeot Ranch
Let's see how to replace the front axle swing arm of a Peugeot Ranch. First we put the car on a column bridge and loosen the wheel pins with a telescopic …read all…
Posted on 23 October 2023 by ScegliAuto
Roof Rack Bars (1) Arm (2) Engine (1) EGR valve (1)

How to replace the Ford Transit key battery

Below I will explain how to replace the remote control key battery on the car, take a small screwdriver and pry the rear part of the remote control, (where there is the ring), at which point unhook the back cover and yes will have access to the compartment containing the battery. Always with the help of the small screwdriver, proceed to make the va and lift the battery out of the housing. Then take the new battery (check the type) and place it on the housing, always making sure to position it with the positive pole facing upwards. Finally, close the back cover by re-hooking it to the key.

Watch the video!


by ScegliAuto

More videos