Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Fit Roof Bars on a Peugeot Ranch

Model: Peugeot Ranch MK 1 - Years: 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007
Part: Roof rack bars

Video tutorial

Start by opening the designated slots on the roof that will accommodate the bases for the bars. Once these slots are opened, cut 4 centimetres of plastic tape for each slot and insert them.

Next, loosen the bolts on the roof bars as much as possible to avoid issues when screwing them in. At this point, detach the clip at each end of the bars. This completes the preparation.

Proceed to insert the supports for the bars into the slots. Next, screw in the screws and close the clips that were previously detached.

Once you have completed this step, you can fit the side covers of the bars, successfully finishing the installation.


Updated on 3 May 2026 by ScegliAuto


Related tutorials

How to Remove the Starter Motor from a Peugeot Ranch
How to Remove the Starter Motor from a Peugeot Ranch
Peugeot Ranch (1996-2008 / MK 1) Open the engine bay, disconnect the battery terminals, and remove the battery. Disconnect the starter motor cables using pliers or a screwdriver, dep…
How to Replace the Front Wishbone on a Peugeot Ranch
How to Replace the Front Wishbone on a Peugeot Ranch
Peugeot Ranch (1996-2008 / MK 1) First, place the vehicle on a column lift and loosen the wheel nuts with a telescopic spanner. Then, lift the car to your preferred height and remove…
How to Remove the EGR Valve from a Peugeot Ranch
How to Remove the EGR Valve from a Peugeot Ranch
Peugeot Ranch (1996-2008 / MK 1) If you notice engine performance issues and an increase in exhaust smoke, the EGR valve may be clogged, causing it to remain slightly open and allowi…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos