Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the rear light bulb on the Peugeot Partner?

Model: Peugeot Partner Tepee B9 - Years: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Tail light bulb

See other generations:
Video tutorial

Replacing one of the bulbs in a vehicle's lighting system is usually not as complex as it may seem, so you can try it yourself. For example, on the Peugeot Partner, to replace the rear light, open the rear door to access the two fixing screws, remove them and pull the light unit outwards.

After this, disconnect the rear connector of the electrical supply cables and open the panel where the bulb holders are installed. Finally, remove the bulb to be replaced and install the new one, then close everything up.


Posted on 26 September 2026 by ScegliAuto


Related tutorials

How do you replace the headlight bulb of the Peugeot Partner?
How do you replace the headlight bulb of the Peugeot Partner?
Peugeot Partner Tepee (1996-2013 / MK 1) Replacing the front headlight bulb of the Peugeot Partner does not require technical experience, the use of specific equipment, or even much time. It…
How to Replace a Bulb in the Rear Light of a 2020 Peugeot Partner?
How to Replace a Bulb in the Rear Light of a 2020 Peugeot Partner?
Peugeot Partner Tepee (2018-2026 / MK 3) Let's see how to replace a bulb in one of the rear lights of the 2020 Peugeot Partner. Specifically, we will change the bulb in the rear light by fol…
How to Replace the Headlight Bulb on a 2020 Peugeot Partner
How to Replace the Headlight Bulb on a 2020 Peugeot Partner
Peugeot Partner Tepee (2018-2026 / MK 3) The attached video tutorial applies not only to the 2020 Peugeot Partner but also to the Citroen Berlingo, as the same method is used to replace the …

How to Replace the Rear Light Bulb on a Citroen C5

To replace the rear light bulb on a 2015 Citroën C5, open the boot of the vehicle and remove the side carpet to access the inside of the light unit. Disconnect the light connector and remove the screw. Take out the light unit and proceed to replace the stop light bulb. Open the light housing and replace the bulb. Follow the same procedure for the right rear light bulb. Once the replacement is complete, refit the light unit, reconnect the connector, and close the side carpet. If the bulb does not work correctly, check the fuse related to the light before replacing it again.

Watch the video!


by ScegliAuto

More videos