Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Starting the Diesel Pump on a Peugeot 206 HDi

Model: Peugeot 206 MK 1 - Years 1998-2012
Part: Fuel pump

In this tutorial video, we will see the main steps to prime a diesel pump on a vehicle, in this case, a Peugeot 206 HDi. First, open the bonnet and remove the protective cover, unscrew the bleed screw of the pump to allow air to escape, and start the engine for a few seconds to fill the pump. Now turn off the engine and screw the bleed screw back on. Restart the engine and check the vehicle's proper functioning: at this point, the job is done, and the problem will be resolved!

Updated on 21 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Timing Belt on a Peugeot 206 1.4 HDi
Replacing the Timing Belt on a Peugeot 206 1.4 HDi
Peugeot 206 (1998-2012 / MK 1) Next, we will discover the steps that will allow you to disassemble and replace the timing belt on the Peugeot 206 1.4 HDi. First, lift the vehicle a…
How to replace the alternator of the Peugeot 206 1.4 HDI
How to replace the alternator of the Peugeot 206 1.4 HDI
Peugeot 206 (1998-2012 / MK 1) Today's main steps will show us how to dismantle and replace the alternator of the Peugeot 206 1.4 HDI, following these simple instructions. First, w…
How to Remove the Starter Motor from the Peugeot 206 1.9 HDI
How to Remove the Starter Motor from the Peugeot 206 1.9 HDI
Peugeot 206 (1998-2012 / MK 1) In today's video tutorial, you will see how to remove and replace the starter motor on the Peugeot 206 1.9 HDI. First, open the bonnet and begin by r…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos