Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Diesel Filter on Peugeot Expert

Model: Peugeot Expert Mark1, MK 1 - Years: 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Diesel fuel filter

See other generations:
Video tutorial

Replacing the diesel filter on a Peugeot Expert? This operation is not too complicated; let's see how to disassemble it. Lift the front bonnet of the vehicle and locate the diesel filter. Unscrew the fastening screws to remove the filter housing (using a socket spanner).

Once the fastening screws are removed, disconnect the pipes and electrical connectors from the top of the housing. Remove the filter housing.

Install the new diesel filter inside the engine bay (connect the pipes and wires) and tighten the screws of the housing. Close the front bonnet.

Start the engine and test the installed part.


Updated on 28 March 2026 by ScegliAuto


Related tutorials

Replacing the Fuel Filter on a Peugeot Expert
Replacing the Fuel Filter on a Peugeot Expert
Peugeot Expert (2008-2016 / Mark2, MK 2) Open the bonnet and observe the engine compartment. If you are facing it and therefore looking towards the cabin, the fuel filter is located on your …
How to Replace the Diesel Pressure Sensor on the Peugeot Expert?
How to Replace the Diesel Pressure Sensor on the Peugeot Expert?
Peugeot Expert (1995-2007 / Mark1, MK 1) To replace the diesel pressure sensor on the Peugeot Expert, open the bonnet to access the engine bay and remove the engine cover. This will allow yo…
How to replace the engine air filter of the Peugeot Expert.
How to replace the engine air filter of the Peugeot Expert.
Peugeot Expert (2016-2025 / Mark3, MK 3) In the following guide, you will find a description of the procedure you need to follow in order to independently replace the engine air filter of yo…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos