Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Driver's Side Glass and Window Regulator Motor on a Peugeot 208

Model: Peugeot 208 A9, MK 1 - Years 2012-2019
Part: Side window

In this video, you will learn how to remove and replace the side glass and window regulator motor on a first-generation Peugeot 208. First, open the front door and start by removing the door panel by unscrewing all the fastening screws located beneath the plastic covers and then unclip the panel from the sides. Once removed, take out the glass seal and unscrew the fastening screws of the window guide; lift and extract the glass. At this point, disconnect the electrical connector of the window regulator motor and unscrew the screws to remove it; then, reassemble everything, following the video to the end!

Updated on 17 April 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Disassembly of the front door panel and side window of the Peugeot 208.
Disassembly of the front door panel and side window of the Peugeot 208.
Peugeot 208 (2012-2019 / A9, MK 1) In this short guide, we will see the information that will allow us to disassemble the front door panel and the side window of the Peugeot 208. First…
Repair of the electric window switch cover of the Peugeot 208.
Repair of the electric window switch cover of the Peugeot 208.
Peugeot 208 (2012-2019 / A9, MK 1) In this video, we see how to repair the switch cover of the Peugeot 208: in this case, the glass on the passenger side would not open; it was only po…
How do you remove the front door panel in the Peugeot 208?
How do you remove the front door panel in the Peugeot 208?
Peugeot 208 (2012-2019 / A9, MK 1) There are several reasons that lead to disassembling the inner door panel of a car, such as in this case the Peugeot 208, for repairing the handle, t…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos