Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Peugeot
  4. :
  5. 207
  6. : How to replace the spark plugs of the Peugeot 207 1.4 16V petrol

Peugeot 207 - Video tutorial

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: Spark plugs
Operation: How to replace the spark plugs of the Peugeot 207 1.4 16V petrol

With the car switched off, pull the handbrake and the hood release lever to open it. Now we can access the engine cover which we need to remove to access the spark plugs. Use a 10 bit socket wrench to remove the two nuts located on one side. Disconnect the power supply of the coils. To do this, lift the support tab of the connector, then pull on the terminal. Remove the vacuum duct to do this. Push on the yellow part of each CLIP by hand and if not successful, use a flat screwdriver. Remove the coil lock. Tip: It is recommended to use a thin plastic tube attached to a vacuum cleaner to clean well around the spark plug housing. Use a socket wrench with a long extension and a size 14 spark plug insert to unscrew the spark plug. It is advisable to unscrew the spark plugs one at a time so as not to let dirt fall into the engine. Take the new spark plug and fit the new spark plug. Insert it first in the bush to be able to present it in its support where it must be screwed. Start screwing by hand, then finish with a wrench and finally tighten a quarter turn. You can use the torque wrench to tighten according to the tightening torque indicated by the manufacturer, or you can also use a protractor. Repeat the operation with the other spark plugs. Proceed to reassemble all the pieces backwards.


Posted on 26 April 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 207 2006-2015 - When should the spark plugs of a Peugeot 207 be replaced? Read Answer
    • 207 2006-2015 - When should the spark plugs of a Peugeot 207 be replaced? Read Answer
    • 207 2006-2015 - How much do the Peugeot 207 1.4 spark plugs cost? Read Answer

How to open the fuel cap on Volkswagen Polo 5 (6R)

In this video tutorial we will see how to open the cap and the fuel flap on Volkswagen Polo 6R, fifth series, by following these simple steps. First of all we go to open the car with the remote control, in order to unlock all the car locks; after which we go to press on the left side of the flap, in order to unlock the actuator and open it, as shown in the video. At this point we are going to unscrew the fuel cap to refuel; once finished the same we can screw the cap and finally close the fuel flap!

Watch the video!


by ScegliAuto

More videos