Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Car Injectors

Model: Peugeot 206 MK 1 - Years 1998-2012
Part: Fuel injectors

The following guide shows how to replace the injectors in your car. Injectors are the evolution of the fuels that were used before and have been replaced because, due to fuel contamination, they would easily clog. If the injectors wear out, they no longer allow adequate fuel supply. To carry out the replacement, a socket wrench of the injector size is required. To find out which injectors are fitted to your car, simply check the manual, then proceed by deactivating the fuel system with the socket wrench and disconnecting the negative battery cable. Next, remove the electrical connector and the fuel intake pipe. The car is now ready for the installation of the new injectors.

Updated on 13 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the fuel injector on the Peugeot 206?
How to replace the fuel injector on the Peugeot 206?
Peugeot 206 (1998-2012 / MK 1) Below are the instructions and various steps necessary to remove the injectors from the vehicle: first, disconnect the electrical connectors of the f…
Indirect Check of Injector Efficiency
Peugeot 206 (1998-2012 / MK 1) There is an indirect method to check the efficiency of the injectors by monitoring the amount of diesel recovered: if the injectors are functioning a…
How to Remove the Injectors from a Peugeot 206
How to Remove the Injectors from a Peugeot 206
Peugeot 206 (1998-2012 / MK 1) Before you start, open the front bonnet to gain the necessary space to work. Begin by removing the entire air filter assembly, unscrewing the relevan…

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos