Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 308
    4. : How to install the rear view camera in a Peugeot 308.

Peugeot 308 - Video tutorial

Model: Peugeot 308 MK 2, T9 - Years 2013-2021
Part: Bodywork
Operation: How to install the rear view camera in a Peugeot 308.

In this video tutorial we can see how it is possible to install the rear view camera in a Peugeot 308. The first thing to do is to buy a new quality camera from an authorized dealer. We must remove all the material present inside the trunk. Remove the placeholders using a screwdriver, as shown in the video; loosen the screws and remove the plastic part by pulling it off; also remove the part above the window. The camera will be positioned on the right side above the plate, so we have to remove the placeholder, as we have to make a hole in it, then the camera will be fixed inside the placeholder. Measure the diameter of the camera, then draw the circle on the placeholder; drill the placeholder with a drill, making a precise hole to fit the camera perfectly. It is recommended that you push out the metal clips of the camera a little to make sure that the metal clips snap into the placeholder. Once the camera is inside you can put them back on top of the bright display. In the trunk connect the two cables: "the white cable" is meant to provide electricity (positive and negative wire) and then there is the black cable. Cut the female side to connect the positive and negative wire to the relay. Now we need to pass the cables through the holes, (you can also help with a metal guide wire to pull the cables).


Posted on 8 October 2022 by ScegliAuto

How to reset the TPMS light of the Volkswagen Polo 2011

The orange tire light indicates the presence of one or more tires with an inflation pressure below the recommended limit. All this is easily solved by inflating them correctly or replacing them in the event of a puncture. After carrying out these operations it is necessary to reset the warning light and therefore also the sensor in order to have new reading data. All you have to do is start the car ignition and then fully open the glove compartment on the passenger side. Locate the two buttons in the right corner and press "Set". At this point the reset is complete and you can turn off the ignition.

Watch the video!


by ScegliAuto

More videos