Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 208
    4. : How to replace the stabilizer bar links in a Peugeot 208

Peugeot 208 - Video tutorial

Model: Peugeot 208 MK 1, A9 - Years 2012-2019
Part: Anti roll bar
Operation: How to replace the stabilizer bar links in a Peugeot 208

In this video tutorial we can see how it is possible to replace the stabilizer bar links in a Peugeot 208, following some basic steps: the first thing to do is to turn off the vehicle and put the handbrake; loosen the wheel bolts, using a socket wrench for wheel nuts N.17, (loosen without completely unscrewing them); lift the front of the car using a hydraulic jack and place safety stands under the vehicle. Next step we must completely unscrew the wheel bolts and remove the wheel from its seat. Clean the stabilizer bar tie rod fasteners, using a wire brush and WD-40 spray. Use a No. 16 socket wrench to unscrew the fasteners that connect the stabilizer bar link to the bar; then remove the cross stabilizer link. If necessary, replace the stabilizer support sleeves. Install the new bar and tighten the fasteners that connect the stabilizer bar link to the bar (use a torque wrench up to a torque of 60 Nm). Tighten the fasteners that connect the stabilizer bar link to the shock strut; use copper grease to treat stabilizer bar joints.


Posted on 9 November 2022 by ScegliAuto

How to replace the Ford Transit key battery

Below I will explain how to replace the remote control key battery on the car, take a small screwdriver and pry the rear part of the remote control, (where there is the ring), at which point unhook the back cover and yes will have access to the compartment containing the battery. Always with the help of the small screwdriver, proceed to make the va and lift the battery out of the housing. Then take the new battery (check the type) and place it on the housing, always making sure to position it with the positive pole facing upwards. Finally, close the back cover by re-hooking it to the key.

Watch the video!


by ScegliAuto

More videos