Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Where is the Starter Motor Located on a Peugeot 206 CC?

Model: Peugeot 206 MK 1 - Years 1998-2012
Part: Starter motor

In this tutorial, you can see where the starter motor is located on a Peugeot 206 CC 1.6 and how to remove it if you need to replace it. It is located at the rear of the engine, on the lower left or right side when looking at the vehicle from the front. To access it, first remove the air filter box by loosening the clamp on the intake, unlocking the clips around the perimeter, and unscrewing the lower fixing bolts. Once done, with the negative terminal of the battery disconnected, unscrew the bolts of the starter motor and disconnect the two terminals.

Updated on 19 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the starter motor of the Peugeot 206?
How do you replace the starter motor of the Peugeot 206?
Peugeot 206 (1998-2012 / MK 1) In order to replace the starter motor of the Peugeot 206, you need to access the bottom of the engine compartment, in the lower right part compared t…
How to Remove the Starter Motor from the Peugeot 206 1.9 HDI
How to Remove the Starter Motor from the Peugeot 206 1.9 HDI
Peugeot 206 (1998-2012 / MK 1) In today's video tutorial, you will see how to remove and replace the starter motor on the Peugeot 206 1.9 HDI. First, open the bonnet and begin by r…
How to Replace the Starter Motor in the Peugeot 206?
How to Replace the Starter Motor in the Peugeot 206?
Peugeot 206 (1998-2012 / MK 1) To replace the starter motor in the Peugeot 206, lift the car with a ramp to access the underside of the engine bay and loosen the screws securing th…

Other guides you may be interested in

    Frequently Asked Questions

    • 206 1998-2012 - Where is the starter motor located on the Peugeot 206? Read answer

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos