Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. RAM
  4. :
  5. 3500
  6. : How to replace the fog light on the Ram 3500

RAM 3500 - Video tutorial

Model: RAM 3500 DS, DJ, MK 4 - Years 2009-2019
Part: Fog lights
Operation: How to replace the fog light on the Ram 3500

If we want to replace the front fog lights of this car with a more performing model, perhaps with LEDs, we can find instructions on how to behave in this video and in the description below. After positioning the car on the bridge, locate the fog light assembly behind the stone guard panel and behind the front bumper. Then proceed to disconnect the electrical power supply terminal and tighten the support screw. Then remove the headlight and take the new one to fix it on its housing and then reconnect the power supply terminal.


Posted on 16 June 2022 by ScegliAuto



How to replace Dodge RAM 3500 low beam and fog light bulbs
RAM 3500 (2009-2019 / DS, DJ, MK 4) To change the headlight lights of the Dodge RAM 3500 we start by raising the bonnet, remove the 3 screws that hold the headlight (2 to the side and 1
Where is the fuse box of the new RAM 3500
RAM 3500 (2019-2024 / MK 5, DT) In this new mini guide of ours dedicated to your brand new RAM 3500 from 2023, we're going to find out where the box containing all the various vehic
How to remove the rear light in the RAM 3500 pick-up?
RAM 3500 (2019-2024 / MK 5, DT) As we can see in this tutorial, disassembling the rear light in the RAM 3500 pickup is very simple. We can do this in case we need to replace a fault

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos