Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the engine oil and oil filter of the RAM Promaster.

Model: RAM Promaster MK 1 - Years 2014-2022
Part: Engine oil

Below is a guide on how to perform routine maintenance on the RAM Promaster Rapid by changing the engine oil and oil filter. Firstly, we need to lift the vehicle and unscrew the oil drain plug found on the oil pan, allowing it to drain into a container for around ten minutes. Next, we unscrew the oil filter, removing and replacing the cartridge with a new one (ensuring the gasket is installed correctly), as shown in the video. Finally, we unscrew the oil filler cap and top up with new oil!

Posted on 26 April 2023 by ScegliAuto

Video tutorial

Related tutorials

Ram Promaster engine oil and oil filter replacement
Ram Promaster engine oil and oil filter replacement
RAM Promaster (2014-2022 / MK 1) Let's find out in this short guide the instructions that will allow us to carry out the routine maintenance service, replacing the engine oil and oil…
How to change engine oil on Ram Promaster
How to change engine oil on Ram Promaster
RAM Promaster (2014-2022 / MK 1) If we want to try our hand at changing the engine oil on this vehicle model, we can find the useful information to follow in the description below an…
How to change the engine oil and filter on your Ram Promaster
How to change the engine oil and filter on your Ram Promaster
RAM Promaster (2014-2022 / MK 1) If we want to proceed with the replacement of the engine oil and the filter on this vehicle model in DIY mode, we will find the information and instr…

Other guides you may be interested in

How to Disassemble and Remove the Rear Camera of a Mercedes CLA

In this video, see how to disassemble and remove the camera (where the license plate light is located) from the rear hatch of a Mercedes CLA. First, open the rear hatch of the car, then remove the rear license plate. Use a screwdriver to remove the screws on the plastic trim of the hatch. Disconnect the plastic trim of the license plate light from the hatch, and use a screwdriver to remove the retaining clips (located between the hatch metal and the plastic trim). Finally, remove the rear camera located in the hatch (disconnect the power connector of the camera) of the car. For reassembly, proceed in reverse order.

Watch the video!


by ScegliAuto

More videos