|
Do it yourself
| |||
| ||||
How to replace the fuel filter on a Renault Kangoo II
Model: Renault Kangoo
MK 2, FC, FW
- Years:
2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Video tutorial
The operation of replacing the fuel filter must be done every 2 years or 40,000 km on the Renault Kangoo II: we open the hood and disconnect the electrical connector of the filter heater. The two fuel lines are fixed with snap connectors. To release them, we press the two green tabs on each side simultaneously and pull the tube upwards. We apply a bit of tape on the opening of each tube to prevent dirt from getting in. We unscrew the 10 mm nut, pull up the entire box to remove it, open the cover; the filter is held in place by a threaded pin. We screw the new screw into the pin and, placing the box on a flat surface, give it a sharp blow to remove it from its seat. We insert the new filter and reassemble everything. We put the box back in place, reconnect the outlet tube, turn on the instrument panel to activate the fuel pump and wait for it to fill the filter and come out of the inlet tube connection, thus purging the air: only now can we reconnect the inlet tube. We clean up the spilled fuel and start the engine, letting it run at idle for a few minutes.
Posted on 8 November 2025 by ScegliAuto
Related tutorials
Renault Kangoo
(2007-2021 /
MK 2, FC, FW)
In this video, you will learn how to replace the fuel filter in a Renault Kangoo 2. First, open the bonnet of the engine compartment and, as shown in…
Renault Kangoo
(1997-2008 /
KC, MK 1, KW)
How to replace the fuel filter on a Renault Kangoo? Follow this guide: open the car's door and pull up the engine compartment release lever located a…
Renault Kangoo
(2007-2021 /
MK 2, FC, FW)
In this video, see how to change the diesel filter on a Renault Kangoo II: open the bonnet, and the filter is located on the left side, right next to…
Other guides you may be interested in
|
How to Reset the Tire Pressure Light on a MG ZS?
On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.053
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |