Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Dipped Beam Bulb on Renault Kadjar?

Model: Renault Kadjar MK 1 - Years: 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022
Part: Headlight bulb

Video tutorial

Fortunately, replacing the bulb in the vehicle shown in the attached video, namely the Renault Kadjar, is quite simple; no technical experience or special tools are required. Here’s what to do: with the instrument panel off, open the bonnet, then proceed to remove the rear inspection cap, made of plastic, from the headlight assembly, then disconnect the connector of the wires that power the bulbs and finally extract the dipped beam bulb from all those present.

Replace it with the new one, test its operation, and reassemble everything.


Posted on 15 April 2026 by ScegliAuto


Related tutorials

How to Change the Bulbs on the Renault Kadjar
How to Change the Bulbs on the Renault Kadjar
Renault Kadjar (2015-2022 / MK 1) On the Renault Kadjar, the replacement of the dipped beam bulb is carried out from the engine bay, working behind the front optical unit. After openi…
Replacing the Front Fog Light Bulb on Renault Kadjar
Replacing the Front Fog Light Bulb on Renault Kadjar
Renault Kadjar (2015-2022 / MK 1) Below are the instructions to remove and replace the front fog light bulb on the Renault Kadjar. First, move to the side of the vehicle and start by …
How to Replace the Front Headlight Bulbs of the Renault Kadjar
How to Replace the Front Headlight Bulbs of the Renault Kadjar
Renault Kadjar (2015-2022 / MK 1) Today’s main steps will show you the procedure for removing and replacing the front headlight bulbs of the Renault Kadjar. First, open the bonnet and…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos