Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Fix False Alarms on Renault Master/Opel-Vauxhall Movano

Model: Renault Master MK 2 - Years 1997-2010
Part: Checks and maintenance

On a van like the Renault Master 2 or the Opel/Vauxhall Movano, false alarms are often caused by the sliding side door contact. Over time and with use, the side door tends to sag and slightly come out of its seat. Consequently, the small contact that should press on the switch when the door is closed no longer applies sufficient pressure; the system then thinks the door is opening and the alarm sounds. The solution is to stick a small spacer on the part of the contact that presses against the door: a piece of rubber, thick adhesive tape, or any material that can act as a "buffer" to ensure the contact is pressed harder when the door is closed.

Posted on 2 October 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Door Trim of the Renault Master III (and Opel Movano B)
How to Remove the Door Trim of the Renault Master III (and Opel Movano B)
Renault Master (2010-2023 / MK 3) To remove the inner door trim of the Renault Master III (and also the Opel Movano B), you need to remove 12 screws: the first two are under the cover…
How to disassemble the door panel of the Renault Master
How to disassemble the door panel of the Renault Master
Renault Master (2010-2023 / MK 3) In this guide we will see the main instructions that will allow us to disassemble and remove the door panel of the Renault Master, but also of the Op…
How to remove the inner panel of a Renault Master MK3
How to remove the inner panel of a Renault Master MK3
Renault Master (2010-2023 / MK 3) …

    Frequently Asked Questions

    • Master 2010-2023 - What problems does the Renault Master 2.3 dCi have? Read answer

How to Reset the EDC Light on an Iveco Eurocargo

The engine light on an industrial vehicle like the Iveco Eurocargo must not be ignored. An engine fault on a heavy vehicle can cause serious damage to itself and others. After servicing, you can reset the EDC light, which is equivalent to an engine light, using the following method. Get into the vehicle, close the doors, and turn on the ignition: press the "call" button on the right side of the steering wheel once, then press the "down" button on the left side of the steering wheel twice. Now press the "menu" button on the right side of the steering wheel (below the phone button) and the "plus" button on the left side of the steering wheel. Now press "Ok" (still on the "call" button) and the light will turn off. Turn off the ignition and turn it back on to verify.

Watch the video!


by ScegliAuto

More videos