Do it yourself
Frequently asked questions about cars and motorcycles

How to Change the Stabiliser Link on a Renault Clio IV

Model: Renault Clio Clio IV, MK 4, Clio 4 - Years 2012-2019
Part: Checks and maintenance

To change the stabiliser link on a Renault Clio IV (costing £19.90 on auto-doc plus shipping), lift the front of the vehicle. Use a jack stand; do not rely solely on your jack, and place the wheels under the car for added safety. The stabiliser link helps keep the wheels firmly on the ground. To remove it, use WD-40. Remove the two ends, lower and upper, with a spanner. At this point, proceed to fit the new link, starting with the lower attachment. Screw in the bolt and then move to the upper part. Now tighten them with a torque wrench to 44 Nm. You can refit the wheels and lower the vehicle. Job done.

Updated on 20 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) Here’s how to replace the stabiliser bar on a Renault Clio III: you can find the kit for both links on Amazon with the code B07TX3DKZ9 for £19.01 plu…
Renault Clio (1998-2005 / Clio 2, MK 2) If you hear noise coming from the front end and handling seems to have worsened, it is likely that a support bush of the suspension arm has failed. B…
Renault Clio (1998-2005 / Clio 2, MK 2) Let's see how to replace the stabiliser bar link on a Renault Clio II: loosen the nuts on the front wheels and then lift the car, supporting it on se…

    Frequently Asked Questions

    • Clio 2012-2019 - What to do if the traction control on a Renault Clio does not start? Read answer
    • Clio 1998-2005 - Where is the heater resistor located on the Renault Clio mk2? Read answer
    • Clio 2012-2019 - Why is the Renault Clio USB port not working? Read answer
    • Clio 2012-2019 - Why does the touch screen not work in the Renault Clio? Read answer
    • Clio 2005-2013 - Where is the horn of a Renault Clio located? Read answer
    • Clio 2005-2013 - What to do if the Renault Clio horn does not work? Read answer

How to reset the tyre pressure warning light on the Suzuki Jimny?

To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off.

Watch the video!


by ScegliAuto

More videos