Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Cabin Fan of the Renault Twingo

Model: Renault Twingo Twingo 2 - Years 2007-2014
Part: Blower motor

Today, let’s discover the main steps to remove and replace the cabin fan of the Renault Twingo. First, get inside the vehicle and start removing the dashboard plastics and the panels located under the driver's side; the fan is located inside the dashboard. At this point, also remove the centre tunnel, then unscrew the mounting screws of the cabin fan to take it out; disconnect its electrical connector. Finally, replace the fan with the new one, applying the reverse procedure!

Updated on 8 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the cabin fan resistor of the Renault Twingo
Replacement of the cabin fan resistor of the Renault Twingo
Renault Twingo (2007-2014 / Twingo 2) In this guide we will see the information related to disassembly and replacement of the cabin fan resistor of the Renault Twingo. First, we get on bo…
How to disassemble the cabin fan of the Renault Twingo
How to disassemble the cabin fan of the Renault Twingo
Renault Twingo (2007-2014 / Twingo 2) Below we will see the instructions that will allow us to disassemble and replace the cabin fan of the Renault Twingo. First of all, we get on board t…
How to Replace the Cabin Fan on the Renault Twingo?
How to Replace the Cabin Fan on the Renault Twingo?
Renault Twingo (2007-2014 / Twingo 2) To replace the cabin fan on the Renault Twingo, you need to remove the protective panel located at the top of the dashboard on the passenger side. On…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos