Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install a New Antenna on the Renault Captur

Model: Renault Captur MK 2 - Years 2019-2026

If you want to customise your vehicle by installing a shark fin-type radio antenna, the following description contains all the useful instructions and necessary steps for the installation. First, purchase an aftermarket antenna model compatible with your vehicle. Then, unscrew the factory antenna and thoroughly clean and degrease the roof surface where the new antenna will be attached. First, stick the double-sided tape provided on the new antenna, then connect the screw of the new antenna cable to the base on the vehicle. Next, remove the other protective film from the double-sided tape and proceed to attach the antenna to the roof.

Updated on 28 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Fit a Shark Antenna on the Renault Captur
Renault Captur (2013-2019 / MK 1) In this video tutorial, you will see how to position the shark fin antenna on the Renault Captur by following a few simple steps that will guide you …
How to Install a Shark Fin Antenna on a Renault Captur?
How to Install a Shark Fin Antenna on a Renault Captur?
Renault Captur (2013-2019 / MK 1) Let's see how to install a shark fin antenna on a Renault Captur as a replacement for the original antenna rod. In fact, the process is the same for …
How to Replace the Antenna on a Renault Captur
How to Replace the Antenna on a Renault Captur
Renault Captur (2013-2019 / MK 1) To replace the antenna on a Renault Captur, open the rear tailgate to access the area where the antenna is located. Disconnect the internal cables an…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos