Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Front Brake Pads on a Renault Clio

Model: Renault Clio MK 3, Clio 3, Clio III - Years 2005-2013
Part: Brake pads

To replace the front brake pads, start by opening the bonnet and unscrewing the cap of the brake fluid reservoir. Lift the front of the vehicle with a jack and place it on axle stands, then remove the wheel and position it under the car. Rotate the disc outward to facilitate the operation; using a large flathead screwdriver, push the old pads outward to retract the piston. Using a 13 mm spanner, unscrew the two bolts holding the caliper while holding the underlying nut with a 15 mm spanner. Once the caliper is free, support it with a cable to the suspension to avoid stressing the brake line. Remove the pads and anti-noise springs, and clean their seats. Refit the new springs and pads, applying a thin layer of copper grease to the ends. Reattach the caliper, securing it with the new screws provided in the kit, tightening them with a torque wrench to 27 Nm. Refit the wheel and repeat the process on the other side. Once finished, replace the brake fluid reservoir cap.

Updated on 9 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) The instructions in this guide will show us the process of disassembling and replacing the front brake pads of the Renault Clio. First, lift the vehi…
Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) In this video, you will see step-by-step instructions for removing and replacing the front brake pads on the fourth generation Renault Clio. First, l…
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) To replace the front brake pads on a Renault Clio III, start by purchasing Brembo pads on eBay with code 272825496362 for £27.45. Open the cap of the…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos