|
Do it yourself
| |||
| ||||
Non-Functioning Heater Fan on the Renault Twingo II
Model: Renault Twingo
Twingo 2
- Years 2007-2014
In this video, we will see what to do if the heating fan is not functioning properly on your Renault Twingo. The first step is to check the fuse: you can do this using the legend found on the cover of the fuse box; the second step is to check the wiring; beneath this, there is a resistor that tends to get very hot, especially when using low settings. In the video, we can see the replacement of the resistor, along with the connections for the fan and wiring; usually, the problem lies in this component if the fan operates partially. To remove it, you need to take out the two screws visible in the video and slide it out of its housing. Another reason for malfunction could be the relay located in the footwell on the right, in the box shown in the video. It can be cleaned or replaced, depending on your skills. The last component is the fan, and to access it, you need to remove the glove compartment. You will need to remove the metal trim with a spatula and then the five screws holding the compartment in place, two of which are located on the outer side. After moving several components, you will find the fan, disconnect the wires and the connector; be very careful when removing it as the plastic is very fragile.
Updated on 11 September 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Twingo
(1993-2007 /
Twingo 1)
To replace the cabin fan on a Renault Twingo, detach the protective panel located at the top of the dashboard, also removing the central panel and th…
Renault Twingo
(2007-2014 /
Twingo 2)
The instructions in this guide will show us how to disassemble and replace the cabin fan of the Renault Twingo. First, we get on board the car and st…
Renault Twingo
(2007-2014 /
Twingo 2)
Today, let’s discover the main steps to remove and replace the cabin fan of the Renault Twingo. First, get inside the vehicle and start removing the …
Other guides you may be interested in
|
How to Bleed the Clutch on a Renault Clio?
To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.194
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |