Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly of disc brake pads on Saab 900

Model: Saab 900 MK 2 - Years 1993-1998
Part: Brake pads

Let's replace the front brake pads of a Saab 900, let's see how they change. We lift the car on a jack up to the desired height, immediately after we go to remove the rim with the respective pins. We unscrew the locking pin of the brake caliper, remove the same from the wheel support. Using a screwdriver, we disassemble the pads to be replaced from the wheel hub caliper, remove the brake caliper. We mount the new pads on the caliper, mount the brake caliper on the disc. We tighten all the pins and mount the wheel. Let's get ready to perform the same operations on the other brake calipers.

Posted on 6 June 2020 by ScegliAuto

Video tutorial

Related tutorials

Saab 900S soft top motor disassembly guide
Saab 900S soft top motor disassembly guide
Saab 900 (1993-1998 / MK 2) Let's see in this guide the main instructions for disassembling and replacing, or repairing, the motor of the hood of the Saab 900. First we open the…
Instructions for Dismantling Saab 900 Hood
Instructions for Dismantling Saab 900 Hood
Saab 900 (1993-1998 / MK 2) Once the hood is fully opened, start by removing the trim that secures the rear of the cover: this is a strip that covers the entire edge of the hood…
Disassembly and reassembly of the bumper on the Saab 900 DIY
Disassembly and reassembly of the bumper on the Saab 900 DIY
Saab 900 (1993-1998 / MK 2) The procedure involves the removal of the bumper from the Saab 900 with the vehicle secured and the ignition off. It starts by identifying the visibl…

Other guides you may be interested in

How to Change the Diesel Filter on a Renault Captur 1.5 dCi

The diesel filter on the Renault Captur is always of the immersion type, but instead of being located at the top of the engine bay, it is positioned lower, inside the front right wheel arch (passenger side), practically under the headlamp. To replace it, it is advisable to lift the vehicle, remove the front right wheel and the corresponding inner lining to access the filter location. Unscrew the fastening nuts of the support clamp to extract it from its housing and disconnect the connector and pipes. At this point, unscrew the fixing screws of the cap, remove the old filter and insert the new one, also replacing the O-ring seals, and then reverse the steps for installation. Before starting the engine, turn the ignition on and off several times to allow the filter to fill.

Watch the video!


by ScegliAuto

More videos