Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Cylinder Head Bolt Replacement

Model: Saab 9 5 Ys3e, MK 1 - Years 1997-2010
Part: Engine

When removing the cylinder head to replace the gasket, it is preferable to use a new set of bolts to secure it; before doing so, re-thread the bolt holes using a tap of the appropriate diameter and thread pitch, taking care not to let shavings fall into the cylinders. At this point, place the new gasket, the cylinder head, and use the new bolt kit applying grease to the tip of the thread and under the head: then use a torque wrench and a calibrated wrench to tighten the bolts following a cross pattern.

Updated on 12 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the Intake Manifold Gasket
Replacement of the Intake Manifold Gasket
Saab 9 5 (1997-2010 / Ys3e, MK 1) Before proceeding with the installation of the intake manifold gasket, ensure that there are no dirt or residue on either the cylinder head side or t…
Replacement of the Complete Engine Gasket Kit
Replacement of the Complete Engine Gasket Kit
Saab 9 5 (1997-2010 / Ys3e, MK 1) First, check with a feeler gauge and an aluminium bar for any tolerances on the seating surface of the cylinder head as shown in the images. Use the …
Replacing Exhaust Manifold Gasket
Replacing Exhaust Manifold Gasket
Saab 9 5 (1997-2010 / Ys3e, MK 1) Once you have removed the exhaust manifold and the old gasket, clean the gasket seating thoroughly, both on the head and on the manifold, to eliminat…

How to Remove the CV Boot on Fiat Panda

Let’s see how to remove the boot from the joint on a Fiat Panda. After positioning your car on a column lift: raise it to a comfortable height to work on, loosen the wheel nuts (using a socket wrench or air drill) and remove the wheel. Begin unscrewing the brake disc bolts with a socket wrench. Remove the bolts located under the disc and completely detach the wheel hub. Pull the arm around the joint with your hands. Fit the new boot (after removing the old one) onto the constant velocity joint, then start reassembling all the parts in reverse order.

Watch the video!


by ScegliAuto

More videos