Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to open a stuck boot lid on the Seat Leon?

Model: Seat Leon MK 3, 5F - Years 2012-2019
Part: Checks and maintenance

In the Seat Leon, it may happen that the boot lid gets stuck, for example, due to a fault with the control button or the lock actuator. In these cases, it is still possible to perform an emergency opening by following the simple procedure shown in this tutorial. First, open the right rear door, then lower the backrest by operating the appropriate release lever. Next, go inside the boot compartment, locate the slot on the rear of the panel, and using a thin spatula, manually unlock the lock.

Updated on 19 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Rear Light on a Seat Leon
Replacing the Rear Light on a Seat Leon
Seat Leon (2012-2019 / MK 3, 5F) Lift the boot lid and remove the round cover shown in the video, of course from the side of the affected light, using a small flat screwdriver. Unscr…
How to Replace the Rear Light Bulb on a Seat León?
How to Replace the Rear Light Bulb on a Seat León?
Seat Leon (2012-2019 / MK 3, 5F) To replace the rear light bulb on a Seat León, open the boot lid to access the interior of the boot near the light. Here, move the carpet to locate t…
Removing the Rear Hatch Panel on the Seat Leon
Removing the Rear Hatch Panel on the Seat Leon
Seat Leon (2005-2013 / 1P) Below are the steps to remove and replace the rear door panel and how to repair the lock on the Seat Leon. First, open the boot lid and start unscrew…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos