Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Battery on a Smart Fortwo 451

Model: Smart Smart 451 - Years 2007-2015
Part: Battery

In this video, you will see the steps to dismantle and replace the engine battery on a Smart Fortwo 451. First, locate the battery at the rear; then open the boot and remove the floor panel to access it. Next, disconnect the two terminals (positive and negative) and unscrew the fixing screw of the central battery bracket; then lift it out and replace it with the new one. Finally, reassemble everything by applying the reverse procedure of disassembly!

Updated on 9 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Key Battery on Smart Fortwo 451
Replacing Key Battery on Smart Fortwo 451
Smart (2007-2015 / 451) Today, you will learn how to open the key remote and replace the internal battery of a Smart Fortwo 451; this operation is very simple and does not r…
How to Replace the Cabin Filter in the Smart Fortwo 450?
How to Replace the Cabin Filter in the Smart Fortwo 450?
Smart (2007-2015 / 451) Replacing the cabin filter in the Smart Fortwo 451 takes about 20 minutes. The filter is located inside the cabin, near the accelerator pedal. To cha…
How to Install the Clutch Actuator on the Smart Fortwo 451
How to Install the Clutch Actuator on the Smart Fortwo 451
Smart (2007-2015 / 451) In today's tutorial video, you will learn how to install the clutch actuator on the Smart Fortwo 451 by following the instructions below. First, lift…

Other guides you may be interested in

    Frequently Asked Questions

    • Smart 2014-2022 - Where is the battery on the Smart 453? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos