Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replace the Alternator Belt on a Smart Car

Model: Smart Smart 450 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007
Part: Alternator

See other generations:
Video tutorial

To access the alternator on a Smart 450, you need to remove the right rear wheel. Loosen the bolts, lift the vehicle, and then remove the bolts followed by the wheel.

Remove the two clips securing the plastic cover and take it off as shown in the video. Loosen the two upper and front bolts of the alternator, and when the alternator belt is no longer under tension, remove it. The video also shows how to replace the air conditioning compressor belt as the procedure is similar.

Proceed in reverse for reassembly. Good luck!


Updated on 18 April 2026 by ScegliAuto


Related tutorials

Replacing the Alternator on a Smart Fortwo
Replacing the Alternator on a Smart Fortwo
Smart (2007-2015 / 451) Is the alternator on your Smart Fortwo damaged? Here’s how to remove it. Disconnect the battery terminals located in the cabin. Open the engine compa…
How to Replace the Alternator Belt on a Smart ForTwo 451 CDI
How to Replace the Alternator Belt on a Smart ForTwo 451 CDI
Smart (2007-2015 / 451) This guide outlines the steps to replace the alternator belt on a Smart ForTwo 451 CDI. Start by lifting the car, removing the right rear wheel, and …
How to Remove the Alternator on Smart 451
How to Remove the Alternator on Smart 451
Smart (1998-2007 / 450) Learn how to remove the damaged alternator from the Smart Fortwo. Lift the car on a jack and remove the rear wheel on the side where the alternator i…

Other guides you may be interested in

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos