|
Do it yourself
| |||
| ||||
How to Change the Gearbox Oil of the Smart Fortwo 451
Model: Smart Smart
451
- Years 2007-2015
To change the gearbox oil of the Smart Fortwo 451, proceed (with the engine warm) as follows: Go to the rear under the car, where you will find the gearbox, and on the left side at the top, you will see the oil filler cap, while on the right side at the bottom is the oil drain plug. Start by unscrewing the oil filler cap with an 8mm hex key, using a spanner (a 17mm spanner was used in the video), then unscrew the oil drain plug with an 8mm hex key, placing a container underneath (be careful as the oil may be hot), clean the plug and its seating, remove the oil filler cap, pour 250ml of new oil through the bottle spout so that the old oil drains out, once all the oil is drained, clean the drain area by spraying oil cleaner, clean the drain plug and screw it back in tightly. Finally, pour new oil into the filler hole until it overflows from the filler hole, then screw the cap back on, clean everything by spraying oil cleaner, and the operation is complete.
Updated on 7 May 2026 by ScegliAuto
Video tutorial
Related tutorials
Smart
(2007-2015 /
451)
Regularly servicing your vehicle means keeping the engine in excellent condition; here’s how to replace the transmission oil in the Smart Fortwo. Fir…
Smart
(2007-2015 /
451)
In this guide, you will find the steps to change the transmission oil of the Smart Fortwo, following the instructions below. First, locate the rear d…
Smart
(2007-2015 /
451)
In today's tutorial video, you will learn how to install the clutch actuator on the Smart Fortwo 451 by following the instructions below. First, lift…
Other guides you may be interested in
|
Frequently Asked QuestionsHow to Connect the Cables to the Battery of the Citroen Xsara Picasso?
In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.150
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |