Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Subaru
    3. : Lucra

How to Replace the Rear Headlight Bulbs on the Daihatsu Tanto - Subaru Lucra

Model: Subaru Lucra MK 1 - Years 2010-2015
Part: Tail light bulb

In today's tutorial video, you will see the main instructions on how to remove and replace the bulbs of the rear headlight on the Daihatsu Tanto, as well as the Subaru Lucra. First, open the trunk and start unscrewing the two screws securing the rear headlight located on the side; then gently remove the headlight from the body, disconnecting the electrical connectors at the back, as shown in the video. At this point, replace the stop, turn signal, or reverse bulbs if necessary, and reassemble everything!

Updated on 4 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads on Daihatsu Tanto - Subaru Lucra
How to Replace the Front Brake Pads on Daihatsu Tanto - Subaru Lucra
Daihatsu Daihatsu Various .. brake pads on the Daihatsu Tanto, as well as the Subaru Lucra. First, raise the vehicle and start by removing the front wheel; then unscrew the bolts.. …
How to replace the rear headlight bulb of the Daihatsu Terios
How to replace the rear headlight bulb of the Daihatsu Terios
Daihatsu Terios (2006-2017 / J200, MK 2, F700) Replacing the rear headlight bulb of the Daihatsu Terios is a simple and quick operation to be carried out independently. Let's start the replacement…
Guide to Replacing the Rear Light Bulbs on the Subaru Outback
Guide to Replacing the Rear Light Bulbs on the Subaru Outback
Subaru Outback (2020-2025 / MK 6, BT) Today's instructions will show you how to remove and replace the rear light bulbs on the Subaru Outback. First, open the tailgate and remove the plas…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos