Do it yourself
| ||||
|
Subaru Forester - Video tutorial
Model: Subaru Forester
SH, MK 3
- Years 2008-2011 Today's guide will show us how to disassemble and replace the lambda probe or oxygen sensor of the Subaru Forester, following these simple steps. First, let's open the car's engine hood and start removing the plastic clips from the partition located above the bumper, in order to remove it; we will find the lambda probe connected to the exhaust manifold underneath, as shown in the video. At this point, let's disconnect the electrical connector and unscrew the lambda probe, removing it and replacing it with the new original one; let's apply the reverse process for reassembly!
Posted on 13 October 2023 by ScegliAuto
Other guides that may interest you |
How to replace the Ford Transit key batteryBelow I will explain how to replace the remote control key battery on the car, take a small screwdriver and pry the rear part of the remote control, (where there is the ring), at which point unhook the back cover and yes will have access to the compartment containing the battery. Always with the help of the small screwdriver, proceed to make the va and lift the battery out of the housing. Then take the new battery (check the type) and place it on the housing, always making sure to position it with the positive pole facing upwards. Finally, close the back cover by re-hooking it to the key. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.018
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |