Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Sym Fiddle
Part: Door lock

To replace the ignition switch of the Sym Fiddle, you need to unscrew the screws that secure the front fairing, located just below the handlebars. Once these are unscrewed, you will need to unscrew the additional screws found along the sides of the front of the scooter, completely removing the front fairing to access the underlying components. At this point, you can disconnect the connectors and wires connected to the ignition switch, allowing it to be freed from its screws and mounting ring. After removal, you can insert a new replacement part and reassemble all previously removed components.

Updated on 4 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Ignition Switch on the Sym Fiddle?
How to Replace the Ignition Switch on the Sym Fiddle?
Fiddle To replace the ignition switch on the Sym Fiddle, loosen the screws securing the front fairing, located at the sides of the handlebars. Once these ar…
How to Replace the Ignition Switch on the Sym Fiddle?
How to Replace the Ignition Switch on the Sym Fiddle?
Fiddle To replace the ignition switch on the Sym Fiddle, unscrew the screws securing the front fairing of the scooter, located just below the handlebars. On…
How do you replace the handles of the Sym Fiddle?
How do you replace the handles of the Sym Fiddle?
Fiddle To replace the handles of the Sym Fiddle, you will need to loosen the screws that secure the front panel of the motorcycle: these screws will be loca…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos