Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Diesel Filters on a Tata Truck?

Model: Tata Tata Various
Part: Diesel fuel filter

The procedure to replace the diesel filters (there are two on the Tata Truck) is straightforward and only requires a spanner of the correct size. Once you locate the position of the two filters, which are next to each other, unscrew the bolt holding the filter in place, being careful as diesel will inevitably spill out. Next, remove the cartridge of the old filter, clean the housing, and insert the new filter. Install the new seal, fill the filter with diesel, and reposition it by tightening the bolt. This operation can be done simultaneously on both filters.

Updated on 7 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the Fuse Box on the Tata Harrier?
Where is the Fuse Box on the Tata Harrier?
Tata Tata Various If you own a Tata Harrier, you must know the exact location of all the various fuses to intervene quickly and effectively in case of electrical fault…
How to Change the Engine Oil on a Tata Ace?
How to Change the Engine Oil on a Tata Ace?
Tata Tata Various The type of engine oil to use in the Tata Ace should have a viscosity rating of 15W40. Obtain a 3-litre container before starting the job. It is also…
How to Reset the Service Light on a Tata Punch?
How to Reset the Service Light on a Tata Punch?
Tata Tata Various To completely clear the Service light on a Tata Punch, insert the ignition key into the ignition switch so that the instrument panel lights up: once …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos