Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Injectors from the Toyota RAV 4

Model: Toyota Rav 4 MK 2, Xa20 - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Fuel injectors

See other generations:
Video tutorial

This guide shows the procedure for removing and replacing the injectors on the Toyota RAV 4. First, open the bonnet of the vehicle and begin by removing the air filter box and the intake duct, unscrewing all the fastening screws. Next, remove the injector rail, taking out each injector one by one, as shown in the video.

At this point, clean or replace the injectors with new ones, securing them properly and finally refitting the rail, following the video tutorial to the end!


Updated on 24 October 2026 by ScegliAuto


Related tutorials

How to Remove the Washer Jets on Toyota Rav4 3
How to Remove the Washer Jets on Toyota Rav4 3
Toyota Rav 4 (2006-2013 / Xa30, MK 3) In this video, see the instructions that will allow you to remove and replace the rear washer jets on a third-generation Toyota Rav4. First, open the…
Where to Find and How to Access the Fuel Pump on a Toyota RAV 4
Toyota Rav 4 (2013-2018 / Xa40, MK 4) The fuel pump on your Toyota RAV 4 is located inside the fuel tank. To access it, start by lifting your vehicle. Then, disconnect the hoses connected…
Removing Air Vents from Toyota RAV 4
Removing Air Vents from Toyota RAV 4
Toyota Rav 4 (1994-2000 / Xa10, MK 1) In today's tutorial video, you will learn how to remove the air vents from a first-generation Toyota RAV 4, following these simple steps. The removal…

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos