Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Light of a Toyota Rav 4

Model: Toyota Rav 4 Xa30, MK 3 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Tail light

See other generations:
Video tutorial

Before you can begin, open the boot to work unobstructed. Start by removing the seal near the light to be replaced.

Next, remove the cover located next to the light. This will give you access to the bolts securing it to the vehicle.

Proceed to loosen and remove these bolts. Once all the bolts are removed, you can pull the light from its housing.

Before fully removing it, simply disconnect the plug, and you will have successfully completed the removal.


Updated on 31 March 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Light and Bulbs on a Toyota RAV 4
How to Replace the Rear Light and Bulbs on a Toyota RAV 4
Toyota Rav 4 (2013-2018 / Xa40, MK 4) In today's tutorial, learn how to remove and replace the rear light and its bulbs on a Toyota RAV 4 by following these simple steps. First, open the …
Dismantling the rear light and bulbs of the Toyota RAV 4.
Dismantling the rear light and bulbs of the Toyota RAV 4.
Toyota Rav 4 (2013-2018 / Xa40, MK 4) In this guide, we will see the instructions that will allow us to disassemble and replace the rear light and its bulbs on the Toyota RAV 4. First, le…
How to Replace the Rear Headlamp Bulb on a Toyota Rav4?
How to Replace the Rear Headlamp Bulb on a Toyota Rav4?
Toyota Rav 4 (2013-2018 / Xa40, MK 4) To replace the rear headlamp bulb on a Toyota Rav4, open the tailgate of the boot so that the screws on either side of the lamp can be loosened. This…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos