Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Light and Bulbs on a Toyota RAV 4

Model: Toyota Rav 4 Xa40, MK 4 - Years: 2013, 2014, 2015, 2016, 2017, 2018
Part: Tail light

See other generations:
Video tutorial

In today's tutorial, learn how to remove and replace the rear light and its bulbs on a Toyota RAV 4 by following these simple steps. First, open the boot lid and start unscrewing the fixing screws located on the sides of the lamp using a 10 mm socket; then, remove the light from the bodywork by disconnecting the bulb connector, as shown in the video.

At this point, replace the bulbs if necessary; then, install the new rear light by applying the reverse procedure!


Updated on 24 July 2026 by ScegliAuto


Related tutorials

Dismantling the rear light and bulbs of the Toyota RAV 4.
Dismantling the rear light and bulbs of the Toyota RAV 4.
Toyota Rav 4 (2013-2018 / Xa40, MK 4) In this guide, we will see the instructions that will allow us to disassemble and replace the rear light and its bulbs on the Toyota RAV 4. First, le…
Replacing the Rear Light of the Toyota RAV4
Replacing the Rear Light of the Toyota RAV4
Toyota Rav 4 (2019-2026 / MK 5, Xa50) Below are the main instructions for removing and replacing the front light and its bulbs of the Toyota RAV4. First, open the rear tailgate and start …
How to Replace the Front Headlamp Bulbs on a Toyota Rav 4
How to Replace the Front Headlamp Bulbs on a Toyota Rav 4
Toyota Rav 4 (2013-2018 / Xa40, MK 4) How to replace the front headlamp bulbs on a Toyota Rav 4? Open the bonnet by pulling the lever located at the bottom right of the dashboard and secu…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos