Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Headlamp on Toyota Rav 4

Model: Toyota Rav 4 Xa40, MK 4 - Years: 2013, 2014, 2015, 2016, 2017, 2018
Part: Headlight

See other generations:
Video tutorial

Today, you will learn how to remove the front headlamps on a Toyota Rav 4. After lifting the bonnet and securing it, undo the two upper bolts, then move on to the lower bolt as clearly shown in the video. One last hidden bolt, located towards the centre of the bumper, holds the headlamp in place.

Once this is undone, you can extract the headlamp from its housing and disconnect the rear connector by pressing on its two tabs. Work carefully while removing the headlamp from the housing to avoid damaging any parts.

Proceed in reverse for reassembly.


Updated on 24 April 2026 by ScegliAuto


Related tutorials

Replacing Front Headlamp on a Toyota Rav 4
Replacing Front Headlamp on a Toyota Rav 4
Toyota Rav 4 (2000-2006 / MK 2, Xa20) Replace the headlamp on a Toyota Rav 4. Lift the bonnet and secure it. Remove the central grille and the bodywork piece below it: there are securing …
How to Replace the Front Headlamp on a Toyota RAV 4
How to Replace the Front Headlamp on a Toyota RAV 4
Toyota Rav 4 (2000-2006 / MK 2, Xa20) To replace the front headlamp on a Toyota RAV 4, open the bonnet to loosen the seven screws securing the upper part of the front bumper. Next, loosen…
How to Replace the Front Headlamp Bulb on a Toyota RAV 4
How to Replace the Front Headlamp Bulb on a Toyota RAV 4
Toyota Rav 4 (2013-2018 / Xa40, MK 4) If you want to learn how to replace the front headlamp bulb on your Toyota RAV 4 (2013-2018), carefully read the following instructions and put them …

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos